run time created geometry Fixed...

From: Stefano Mottura (mottura++at++itia.mi.cnr.it)
Date: 01/13/2000 03:24:57

• Next message: Mark Ippolito: "RE: run time created geometry Fixed..."
• Previous message: Russ Schaaf: "Re: compiling with static libraries"
• Next in thread: Mark Ippolito: "RE: run time created geometry Fixed..."
• Reply: Mark Ippolito: "RE: run time created geometry Fixed..."
• Reply: Angus Dorbie: "Re: run time created geometry Fixed..."

Hello all!
Now, after some other experiment, I found that if I set the "Single
Thread" mode in LynX the application runs properly, in others words the
run-time created pfGeoSet (and linked to the underlying pfNode of the
vgObject) appears in the vgScene! But I cannot understand why this
beautiful thing happens only in Single Thread mode, I have an OnyX2
2CPU, and if use the "Default" MP Mode in LynX the pfGeoSet doesn't
appears!

howeverm any comments is appreciated!

thank you

Bye

Stefano Mottura

--
Dr. Stefano Mottura
VME (Virtual Manufacturing Environment) Group
ITIA-CNR
Institute of Industrial Technologies and Automation
National Research Council of Italy
V.le Lombardia, 20/A
20131 Milan
Italy
tel. +39 02 70643961
fax. +39 02 70643915
mottura++at++itia.mi.cnr.it

• Next message: Mark Ippolito: "RE: run time created geometry Fixed..."
• Previous message: Russ Schaaf: "Re: compiling with static libraries"
• Next in thread: Mark Ippolito: "RE: run time created geometry Fixed..."
• Reply: Mark Ippolito: "RE: run time created geometry Fixed..."
• Reply: Angus Dorbie: "Re: run time created geometry Fixed..."

This archive was generated by hypermail 2b29 : Thu Jan 13 2000 - 03:22:30 PST

This message has been cleansed for anti-spam protection. Replace '++at++' in any mail addresses with the '@' symbol.