From: Anthony Bavuso (a.t.bavuso++at++larc.nasa.gov)
Date: 01/11/2000 14:23:26
I have a multi-pipe/multi-channel projector display system that I would like
to configure perfly to use.
Ideally I would like to use the command line features but I haven't been
able to figure out exactly which/how to use them from the man pages. Can
someone give me the command line switches I would need to setup the FOV and
channel ordering for the following hardware setup? Thanks.
My display system hardware is configured as follows. There are 3 pipes and
six channels of interest, 2 channels per pipe.
Pipe 4, channel 0 and channel 1 respectively are the left and right side
window cockpit views.
The pilots forward view is broken into 4 tiles. Pipe 1, channel 0 and
channel 1 respectively are the lower and upper left tiles. Pipe 0, channel
0 and channel 1 respectively are the lower and upper right tiles. Also the
forward view projectors i.e. all 4 channels from pipes 0 and 1 are
tilted -90 degrees onto their side.
This archive was generated by hypermail 2b29 : Tue Jan 11 2000 - 14:22:52 PST