Re: BCM5704 performance questions.

["Michael Chan" <mchan@xxxxxxxxxxxx>]

On Fri, 2005-06-10 at 14:09 -0700, Ben Greear wrote:

> I commented out the code and ran the pktgen test again.  It may be a small
> bit better, but not much:  770Mbps in one direction, 750Mbps in the other.
> 

The latest tg3 driver will print out the dma_rwctrl at probe time. Can
you check the value to make sure ONE_DMA is disabled? Bit 14 sets
ONE_DMA.

> Have you done any tests with 2 tg3 NICs in a single machine to see if they
> can run at or near line speed (full duplex)?
> 

Yes, we have years ago but not with the tg3 driver. We set up the 5704
to bridge (or route, I don't remember) one port to the other. It cannot
bridge at line-rate with the ONE_DMA workaround enabled.