On October 27, 2004 00:33, Shawn Starr wrote:
NETDEV WATCHDOG: eth0: transmit timed out
e1000: eth0: e1000_watchdog: NIC Link is Up 1000 Mbps Full Duplex
NETDEV WATCHDOG: eth0: transmit timed out
eth0 Link encap:Ethernet HWaddr 00:0D:60:CA:C1:97
inet addr:192.168.10.5 Bcast:192.168.10.255
Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4294883167 errors:4294370903 dropped:4294796898
overruns:4294882097 frame:4294711699 TX packets:4294883949
errors:4294796898 dropped:0 overruns:0 carrier:4294711699
collisions:4294882097 txqueuelen:1000
RX bytes:470309 (459.2 KiB) TX bytes:108971 (106.4 KiB)
Base address:0x8000 Memory:c0220000-c0240000
I also get 4bn errors reported using e1000 on a T42 (2378-DXU) after
coming out of APM suspend. However, my network interface seems to work
normally otherwise, as far as I can tell. It always reports 100Mbps.
eth0 Link encap:Ethernet HWaddr 00:0D:60:FF:0D:9A
inet addr:172.16.22.206 Bcast:172.16.22.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:887386 errors:4294967254 dropped:4294967284
overruns:4294967290 frame:4294967278
TX packets:452521 errors:4294967284 dropped:0 overruns:0
carrier:4294967278
collisions:4294967290 txqueuelen:1000
RX bytes:1319970165 (1.2 GiB) TX bytes:32622656 (31.1 MiB)
Base address:0x8000 Memory:c0220000-c0240000
I'm using 2.6.9 (FC3), which includes e1000 version 5.3.19-k2. Looks
like there is a newer version at http://sourceforge.net/projects/e1000/
(maybe the same as in 2.6.10-rc1?).
James.
Please cc: any replies to me - thanks (IANAKH).
|