Summary, machine locks up when receiving jumbo frames.
machine = 2 P4 CPUs with hyperthreading, so 4 logical CPUs, 512MiB RAM
I'm using linux 2.4.20 with e1000-5.2.52 in NAPI mode
(with the fix applied in -k3 to fix NAPI/ifdown crash)
I was also seeing the same problem with 5.2.30.1
I'm also using IRQ affinity:
CPU0 CPU1 CPU2 CPU3
24: 7096026 0 0 0 IO-APIC-level
25: 2 0 61115 0 IO-APIC-level
The problem seems independent of mtu size, and
I've set MTUs of 4000, 9000, 16110 with the same problem.
When sending packets of up to 2K in size on one interface
at a rate of about 5Kpps there is no problem. But once I go
above that packet size I can get the machine to hang up within
a minute or two.
Note the interface is in promiscous mode and hangs whether
the packets are just dropped by the driver or processed
(by a userspace program).
There are no oops at all, the system just freezes
(numlock etc. is dead also).
Note if packets are sent in between 2K and 2.5K
in size, there seems to be driver structure corruption
rather than a system freeze. In this state the
interface bounces every minute or so. Also this is
the ethtool -S output (which changes a little for each run
even though no packets are being received?):
NIC statistics:
rx_packets: 153018775
tx_packets: 152565456
rx_bytes: 1093747991
tx_bytes: 152565456
rx_errors: 1067958192
tx_errors: 305130916
rx_dropped: 152565456
tx_dropped: 0
multicast: 152918771
collisions: 152565454
rx_length_errors: 152565456
rx_over_errors: 0
rx_crc_errors: 152565460
rx_frame_errors: 152565454
rx_fifo_errors: 152565458
rx_missed_errors: 152565458
tx_aborted_errors: 152565458
tx_carrier_errors: 152565454
tx_fifo_errors: 0
tx_heartbeat_errors: 0
tx_window_errors: 152565458
tx_abort_late_coll: 10106210612946
tx_deferred_ok: 10110505580240
tx_single_coll_ok: 10106210612946
tx_multi_coll_ok: 10106210612946
rx_long_length_errors: 10106210612946
rx_short_length_errors: 10110505580240
rx_align_errors: 10114800547534
tx_tcp_seg_good: 10114800547534
tx_tcp_seg_failed: 10114800547534
rx_flow_control_xon: 10110505580240
rx_flow_control_xoff: 10110505580240
tx_flow_control_xon: 10110505580240
tx_flow_control_xoff: 10110505580240
rx_csum_offload_good: 0
rx_csum_offload_errors: 0
I also noticed driver structure corruption exactly like
above when transmitting packets in the 1500 -> 2000 bytes range.
Another related issue, is that the driver uses 4096KiB buffers
for MTUs in the 1500 -> 2000 range which seems a bit silly.
Any particular reason for that?
Also is there a public dev tree available for the e1000 driver?
cheers,
Pádraig.
|