| To: | Timothy I Mattox <tmattox@xxxxxxxxxxxx> |
|---|---|
| Subject: | Re: [PATCH] tulip, kernel 2.4.26-rc2, 2nd try |
| From: | Jeff Garzik <jgarzik@xxxxxxxxx> |
| Date: | Fri, 09 Apr 2004 15:33:19 -0400 |
| Cc: | tulip-devel@xxxxxxxxxxxxxxxxxxxxx, netdev@xxxxxxxxxxx |
| In-reply-to: | <Pine.LNX.4.43.0404091519200.19041-100000@xxxxxxxxxxxxxxxxxxxxxxxx> |
| References: | <Pine.LNX.4.43.0404091519200.19041-100000@xxxxxxxxxxxxxxxxxxxxxxxx> |
| Sender: | netdev-bounce@xxxxxxxxxxx |
| User-agent: | Mozilla/5.0 (X11; U; Linux i686; en-US; rv:1.4) Gecko/20030703 |
Timothy I Mattox wrote: Resubmitting ADMtek Comet MII support patch... Here is a patch for the tulip driver found in kernel 2.4.26-rc2 This adds MII functionality to the ADMtek Comet flavor of the tulip, specifically, the ability to detect and report the link status with MII. This is critical for use with newer channel bonding drivers. I've tested on several Linksys LNE100TX v4.1 PCI cards, as well as on an HP Pavilion N5475 laptop with a built-in NIC that is detected as this same model of chip. I have over 750 of this model tulip card in use in various beowulf clusters. This patch was modeled after Donald Becker's tulip.c:v0.98 1/8/2004, but the specific bits from his driver have been there for about two years. (See: http://sourceforge.net/mailarchive/message.php?msg_id=1841280)
Looks OK, but can you test without netif_carrier_xxx commented out?
I would prefer to leave those active.
Jeff
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [PATCH][ATM]: [nicstar] using dev_alloc_skb() (reported by "Johnston, Jayme" <Jayme.Johnston@xxxxxxxxxxx>), David S. Miller |
|---|---|
| Next by Date: | Re: [PATCH] IPV6: Mark MLDv2 Report as known, David S. Miller |
| Previous by Thread: | Re: [PATCH] tulip, kernel 2.4.26-rc2, 2nd try, Francois Romieu |
| Next by Thread: | Re: [PATCH] tulip, kernel 2.4.26-rc2, 2nd try, Timothy I Mattox |
| Indexes: | [Date] [Thread] [Top] [All Lists] |