Hi.
I have HP 10/100VG AnyLan EISA card. My machine is a HP Netserver
4d/66LE. 486, EISA only.
After latest changes in hp100 driver, it stopped working for me.
It oopsed as module on 2.6.2 (and I experienced kernel panic when hp100
was build in) but after Oops I was able to get interface up and working:
hp100: eth0: HP J2577 at 0x2c38, IRQ 5, EISA bus, 128k SRAM (rx/tx 75%).
hp100: eth0: Memory area at 0xd0000-0xd3fff (virtual base c00d0000).
hp100: eth0: Adapter is attached to 10Mb/s network (10baseT).
On 2.6.3 it just Oopsed and didn't work. On 2.6.4-rc1 it does
not oops but it doesn't work (neither as module nor as build in kernel).
Module loads cleanly but does nothing - I can't get interface up,
nothing in dmesg.
If you need more details, logs etc., please tell me what you need to
know.
I don't know if it's related to this problem but at earlier stage of
booting I'm getting following messages:
EISA: Probing bus 0 at eisa0
EISA: Mainboard HWPC061 detected.
EISA: slot 2 : HWP1940 detected (disabled).
EISA: Detected 1 card.
Card works fine on 2.4.* (tested on 2.4.16, 2.4.24,25,26-pre1) :
hp100: eth0: HP J2577 at 0x2c38, IRQ 5, EISA bus, 128k SRAM (rx/tx 75%%).
hp100: eth0: Memory area at 0xd0000-0xd3fff (virtual base c00d0000).
hp100: eth0: Adapter is attached to 10Mb/s network.
--
,d$$$$$P.d$$b d$P ,gd$$$$$,gd$$$$g. ,$$$b._$$P RLU #172534
ggggggggggggg. ggs ,gg ,gg ,gg ggp,ggggg Paweł Sokołowski
d$P""""'""""Y$$. d$P d$P d$P ,d$Pd$P `Y$$P falcon@xxxxxxxxxxxxxxx
d$P Y$$d$$$$$P`Y$$$$$'`Y$$$$$P'd$P d$P Replicant (M) Des: Falcon
|