My configuration.....
For Machine-1
# ip -6 addr
1: lo: <LOOPBACK,UP> mtu 16436 qdisc noqueue
inet6 ::1/128 scope host
8: epmac1: <BROADCAST,UP> mtu 1500 qdisc pfifo_fast qlen 100
inet6 3ffe:1234::2/128 scope global
inet6 fe80::a00:6ff:fe2b:9654/10 scope link
Machine-2
#ip -6 addr
1: lo: <LOOPBACK,UP> mtu 16436 qdisc noqueue
inet6 ::1/128 scope host
2: eth0: <BROADCAST,UP> mtu 1500 qdisc pfifo_fast qlen 100
inet6 3ffe:1234::1/128 scope global
inet6 fe80::2b0:d0ff:fed2:65ff/10 scope link
I connected both the machines (directly) using cross cable and using sendip
utility(ipv6 packet generator)
usage: sendip -p ipv6 -p tcp destaddr
i sent few packets with ipv6.
I used ethereal to capture the data(in promiscous mode).
Here source=3ffe:1234::1 and dest=3ffe:1234::2.
when i send an ipv6 packet using sendip,
the source sends ICMPv6 Neighbor solicitation,
but i dont see a reply from the dest,which is expected.
Is the method correct ?? Or other alternative method ?? Advice pls.
Regds,
-San
---------------------------------------------
On Thu, 20 Feb 2003 YOSHIFUJI Hideaki / $B5HF#1QL@(B wrote :
>In article <20030220104719.835.qmail@xxxxxxxxxxxxxxxxxxxxxxxx> (at 20 Feb 2003
>10:47:19 -0000), "santosh kumar gowda" <ipv6_san@xxxxxxxxxxxxxx> says:
>
> > I tried connecting only these two machines using a cross cable and
> > sending IPv6 packets. But it failed. Is it correct to do so ???
>
>Please show your exact configuration / command / output, etc.
>What do you mean by "it failed"?
>Any messages?
>
>--
>Hideaki YOSHIFUJI @ USAGI Project <yoshfuji@xxxxxxxxxxxxxx>
>GPG FP: 9022 65EB 1ECF 3AD1 0BDF 80D8 4807 F894 E062 0EEA
>
>
|