Linux FailSafe™ Administrator's Guide
PrevNext

Chapter 8. Testing Linux FailSafe Configuration

Table of Contents
8.1. Overview of FailSafe Diagnostic Commands
8.2. Performing Diagnostic Tasks with the Cluster Manager GUI
8.2.1. Testing Connectivity with the Cluster Manager GUI
8.2.2. Testing Resources with the Cluster Manager GUI
8.2.3. Testing Failover Policies with the Cluster Manager GUI
8.3. Performing Diagnostic Tasks with the Cluster Manager CLI
8.3.1. Testing the Serial Connections with the Cluster Manager CLI
8.3.2. Testing Network Connectivity with the Cluster Manager CLI
8.3.3. Testing Resources with the Cluster Manager CLI
8.3.4. Testing Failover Policies with the Cluster Manager CLI

This chapter explains how to test the Linux FailSafe system configuration using the Cluster Manager GUI and the Cluster Manager CLI. For general information on using the Cluster Manager GUI and the Cluster Manager CLI, see Chapter 4.

The sections in this chapter are as follows:

PrevHomeNext
Backing Up and Restoring Configuration With Cluster Manager CLI Overview of FailSafe Diagnostic Commands