xfs_repair fails after trying to format log cycle?

[Emmanuel Florac]

Le Fri, 3 Jun 2016 22:28:54 -0400
Andrew Ryder <tireman at shaw.ca> écrivait:

> Sorry to dig up old stuff here but after replacing hardware and
> pulling my hair out to no end, I traced the source of the problem out.
> 
> On every drive in the array, the points on the PCB which the contacts 
> for the drives motors and head/actuators make contact with were
> oxidized enough to cause the issue. I ended up pulling the PCB off
> each drive and cleaning them as well as cleaning out all other cable
> and drive connectors from the HBA outward and everything is happy
> again.
> 
> http://s33.postimg.org/uhjmvw4dr/Not_Cleaned.jpg
> http://s33.postimg.org/xo94ieii7/Partial_Cleaned_1.jpg
> http://s33.postimg.org/hoqgyumgf/Partial_Cleaned_2.jpg
> http://s33.postimg.org/68k20t8a7/Partial_Cleaned_3.jpg
> 

Good job, that was quite unexpected :) Are you next to the
seashore?

-- 
------------------------------------------------------------------------
Emmanuel Florac     |   Direction technique
                    |   Intellique
                    |	<eflorac at intellique.com>
                    |   +33 1 78 94 84 02
------------------------------------------------------------------------