At 19:54 11-6-2001 -0400, Daniel Spratlen wrote:
Hello xfsers,
First off, thank you for your hard and wonderful work. Now for my
question. I have an IBM x220 server, and I can't get RH7.1-xfs to boot
unless I use the boot disk that I created during the install. System
configuration is as follows:
# more lilo.conf
boot=/dev/sda
map=/boot/map
install=/boot/boot.b
prompt
timeout=50
message=/boot/message
linear
default=linux
You say that you have altered the bios to make it boot from disk 6?
You are NOT writing a boot sector to disk 6 with this config.
If I think I am right sda == id0 and sdg == id6
Edit your lilo.conf to make3 boot=/dev/sda6
It should then write the MBR to the seventh disk in the array.
--
Seth
Every program has two purposes one for which
it was written and another for which it wasn't
I use the last kind.
|