Le Wed, 23 Feb 2011 16:01:09 +0100
Erik Gulliksson <erik@xxxxxxxxxxxxxx> écrivait:
> Hi Emmanuel,
>
> Thanks for your prompt reply.
>
> On Wed, Feb 23, 2011 at 3:46 PM, Emmanuel Florac
> <eflorac@xxxxxxxxxxxxxx> wrote:
> >
> > What firmware version are you using?
> >
> > ( tw_cli /cX show firmware )
>
> # tw_cli /c0 show firmware
> /c0 Firmware Version = FE9X 4.10.00.007
>
OK so this is the latest, or close.
>
> >
> > Augh. That sounds pretty bad. What does " tw_cli /cX/uY show all"
> > look like?
>
> Yes, it is bad - a decision has been made to replace these disks with
> "enterprise"-versions (without TLER/ERC problems etc).
Typical error, alas. Save a couple hundred euros with cheap drives, to
store terabytes of data worth a lot.
> Tw_cli produces
> this output for the volume:
>
> # tw_cli /c0/u0 show all
> /c0/u0 status = OK
> /c0/u0 is not rebuilding, its current state is OK
> /c0/u0 is not verifying, its current state is OK
> /c0/u0 is initialized.
> /c0/u0 Write Cache = on
> /c0/u0 Read Cache = Intelligent
> /c0/u0 volume(s) = 1
> /c0/u0 name = xxx
> /c0/u0 serial number = yyy
> /c0/u0 Ignore ECC policy = off
> /c0/u0 Auto Verify Policy = off
> /c0/u0 Storsave Policy = protection
> /c0/u0 Command Queuing Policy = on
> /c0/u0 Rapid RAID Recovery setting = all
> /c0/u0 Parity Number = 2
>
> Unit UnitType Status %RCmpl %V/I/M Port Stripe
> Size(GB)
> ------------------------------------------------------------------------
> u0 RAID-6 OK - - - 256K
> 12572.8
So the RAID array looks OK, the RAID controller doesn't report any
particular problem. You said it was reported as 0 K. Where did you see
0 K reported?
What gives "dmesg | grep 3w-9xxx" ? and "tw_cli alarms" ? Was the
filesystem under heavy write when the problem occured ?
I'd start with launching a RAID verify, to detect and correct possible
on-disk coherency problems (it can't hurt anyway):
tw_cli /c0/u0 start verify
Then "tail -f /var/log/messages | grep 3w-9xxx" ...
I suppose that there are no problems to be discovered. Most probably
IOs to the array were lost because of the bus reset.
--
------------------------------------------------------------------------
Emmanuel Florac | Direction technique
| Intellique
| <eflorac@xxxxxxxxxxxxxx>
| +33 1 78 94 84 02
------------------------------------------------------------------------
|