I've seen things you people wouldn't believe. You writing:
>Pawel> I don't know if it's related to this problem but at earlier stage of
>Pawel> booting I'm getting following messages:
>Pawel> EISA: Probing bus 0 at eisa0
>Pawel> EISA: Mainboard HWPC061 detected.
>Pawel> EISA: slot 2 : HWP1940 detected (disabled).
>Pawel> EISA: Detected 1 card.
>Try passing 'eisa_bus.enable_dev=2' to your kernel parameters. Your
>card is tagged as unconfigured by BIOS, and thus is skipped by the
>probing logic. See Documentation/eisa.txt for details.
This machine has RAM BIOS booted from floppy. I ran it and EISA
configure utility to check this once more. Card is enabled and not
locked. I added eisa_bus.enable_dev=2 parameter but it didn't help much.
I'm getting:
EISA: Probing bus 0 at eisa0
EISA: Mainboard HWPC061 detected.
EISA: slot 2 : HWP1940 detected (forced enabled).
EISA: Detected 1 card.
I added this final entry you mailed but nothing changed. Still - module
loads and unloads cleanly and without any warnings on 2.6.4-rc1. But
does nothing - not a single line in logs/dmesg after it's loaded. Card
does not work after modprobe, I can't get interface up.
If you need more details or some config files, please, let me know.
--
,d$$$$$P.d$$b d$P ,gd$$$$$,gd$$$$g. ,$$$b._$$P RLU #172534
ggggggggggggg. ggs ,gg ,gg ,gg ggp,ggggg Paweł Sokołowski
d$P""""'""""Y$$. d$P d$P d$P ,d$Pd$P `Y$$P falcon@xxxxxxxxxxxxxxx
d$P Y$$d$$$$$P`Y$$$$$'`Y$$$$$P'd$P d$P Replicant (M) Des: Falcon
|