2016 Cars get priced to move when they need to bring in the 2017 models.

["Burt Ibarra" <burt.ibarra@xxxxxxxxxxxxxxxxx>]

Airport:

My 2006 CTS runs fine once started. However, in the last month or so it's had difficulty cranking on occasion. When I turn the ignition to start, it sometimes delays to crank. It's as if there is a pause. Today, it actually wouldn't start at all and I had to turn the ignition to off and then back to start a couple times before it started. This has caused my Check Engine Light to come on a few times. It gives the following codes: P0523: Oil Pressure Sensor Circuit High P0601: Internal Control Module Memory Check One one occasion It recorded misfire codes P0300, P0301, P0302; but that only happened once, on a delayed start. It doesn't seem to matter if the engine is cold or warm. Any ideas or suggestions on what to test would be greatly appreciated. Thanks, Brandon

Sleek, shiny, and ready to hit the road!

Dive off the lot in a new 2016 or 2017 for a lot less than you would expect...

Compare New Cars

• No haggle experience
• Compare pricing across multiple dealers
• Drive off with confidence knowing you got the best deal

New Car Comparisons

I am working on a friend of mine's 1975 ford F-250 truck his

charging system is not charging and when i went to

the auto parts store i found out the

alternator was not the st one so the parts store matched up the alternator which is a

DELCO REMY GM alternator and tested it and the new one was good.

So i reinstalled it and the vehicle is still

not getting a charge the question is on the wiring of the alternator

There is a battery terminal post (on the back side of the alternator )

On the side toward the back a 2 prong plug opening

the battery terminal is connected to my starter solenoid on the battery side

the 2 prong plug has only 1 wire on the # 2 terminal looping to the battery terminal on the back

the part store tested it again for me and it was good i noticed the 2 prong plug they were testing with

had 2 wires connected not one so is the alternator not turning on because the # 1 terminal on what i believe

is the internal voltage regulator is not connected

i need to know what is wrong with the

wiring because i checked the wiring in the truck and there is no breaks causing it to not work

Unsub-message Center
Beltran & Sellars Quick-Net.
6506 Pine Train Road.,
Tinley Park, IL 60477