Hello,
I'm trying to understand the structure of host0, host1, host2, etc in
regards to IDE devices. I did read Richards FAQ, and he did discuss this
for scsi devices, but I didn't see the logic explained for the IDE devices or
whatever determines the host# scheme. ( ...or it was in there, but I didn't
understand it ) If someone could explain this, I sure would appreciate it.
In regards to the /bus#/target# logic, maybe someone could confirm my
understanding of this as well as I have listed below.
/bus0/target0 = primary master
/bus0/target1 = primary slave
/bus1/target0 = secondary master
/bus1/target1 = secondary slave.
I'm trying to get this fellows internal zip drive working on his system, but
because he has a different HD and Zip configuration off his IDE slots than I
do, it's necessary I understand how to figure this out so I can get his block
device (part4) in the right place for his system.
Thanks,
Robert
|