Return to serial.h CVS log

Up to [Development] / linux-2.6-xfs / include / asm-arm / arch-sa1100

Initial Import 2.6.0

/*
 * include/asm-arm/arch-sa1100/serial.h
 * (C) 1999 Nicolas Pitre <nico@cam.org>
 *
 * All this is intended to be used with a 16550-like UART on the SA1100's 
 * PCMCIA bus.  It has nothing to do with the SA1100's internal serial ports.
 * This is included by serial.c -- serial_sa1100.c makes no use of it.
 */

#include <linux/config.h>

/* Standard COM flags */
#define STD_COM_FLAGS (ASYNC_BOOT_AUTOCONF | ASYNC_SKIP_TEST)

/*
 * Rather empty table...
 * Hardwired serial ports should be defined here.
 * PCMCIA will fill it dynamically.
 */
#ifdef CONFIG_SA1100_TRIZEPS

#define STD_SERIAL_PORT_DEFNS	\
       /* UART	CLK     	PORT		IRQ		FLAGS		*/ \
	{ 0,	1500000,	TRIZEPS_UART5,	IRQ_GPIO16,	STD_COM_FLAGS },   \
	{ 0,	1500000,	TRIZEPS_UART6,	IRQ_GPIO17,	STD_COM_FLAGS }

#else

/*
 * This assumes you have a 1.8432 MHz clock for your UART.
 *
 * It'd be nice if someone built a serial card with a 24.576 MHz
 * clock, since the 16550A is capable of handling a top speed of 1.5
 * megabits/second; but this requires the faster clock.
 */
#define BASE_BAUD ( 1843200 / 16 )

#define STD_SERIAL_PORT_DEFNS	\
       /* UART	CLK     	PORT		IRQ	FLAGS		*/ \
	{ 0,	BASE_BAUD,	0, 		0,	STD_COM_FLAGS },   \
	{ 0,	BASE_BAUD,	0, 		0,	STD_COM_FLAGS },   \
	{ 0,	BASE_BAUD,	0, 		0,	STD_COM_FLAGS },   \
	{ 0,	BASE_BAUD,	0, 		0,	STD_COM_FLAGS }

#endif

#define EXTRA_SERIAL_PORT_DEFNS