Running Ubuntu 9.04 kernel 2.26.28.14 generic
Drive mounts fine.
xfs_repair shows no errors
sudo xfs_repair /dev/sdg1
Phase 1 - find and verify superblock...
Phase 2 - using internal log
- zero log...
- scan filesystem freespace and inode maps...
- found root inode chunk
Phase 3 - for each AG...
- scan and clear agi unlinked lists...
- process known inodes and perform inode discovery...
- agno = 0
- agno = 1
- agno = 2
- agno = 3
- process newly discovered inodes...
Phase 4 - check for duplicate blocks...
- setting up duplicate extent list...
- check for inodes claiming duplicate blocks...
- agno = 0
- agno = 1
- agno = 2
- agno = 3
Phase 5 - rebuild AG headers and trees...
- reset superblock...
Phase 6 - check inode connectivity...
- resetting contents of realtime bitmap and summary inodes
- traversing filesystem ...
- traversal finished ...
- moving disconnected inodes to lost+found ...
Phase 7 - verify and correct link counts...
done
xfs_check did move a few things around but finished fine
sudo xfs_fsr -v /dev/sdg1 <== This is just so far it is still running.
/media/Films start inode=0
ino=140
bad read of 0 bytes from ino=140: Input/output error
ino=139
extents before:66 after:8 ino=139
ino=145
extents before:42 after:7 ino=145
ino=146
extents before:40 after:8 ino=146
ino=143
bad read of 0 bytes from ino=143: Input/output error
ino=144
extents before:27 after:8 ino=144
ino=8763008
bad read of 0 bytes from ino=8763008: Input/output error
ino=8763059
bad read of 0 bytes from ino=8763059: Input/output error
ino=8763057
extents before:307 after:12 ino=8763057
ino=8763058
extents before:259 after:11 ino=8763058
ino=8763024
bad read of 0 bytes from ino=8763024: Input/output error
ino=8763055
kk
extents before:125 after:10 ino=8763055
ino=8763030
bad read of 0 bytes from ino=8763030: Input/output error
ino=8763060
bad read of 0 bytes from ino=8763060: Input/output error
ino=8763056
extents before:62 after:13 ino=8763056
ino=8763066
Now my issue is how do I fix it if xfs_repair doesn't see a problem.
Anything getting copied to the drive works fine in place wasn't until i
tried to move it off I noticed the issue. Some things copy fine from it
several others fail. Then i get Input/output error. It is a full 1tb drive .
WD mybook it lost power which I think is what caused this issue. How can I
correct the issue. Everything I try takes a hell of a long time and doesn't
yield a positive result
--
View this message in context:
http://www.nabble.com/xfs-i-O-error-tp24742623p24742623.html
Sent from the Xfs - General mailing list archive at Nabble.com.
|