[Top] [All Lists]

RE: Linux 2.4.18 freeze running dbench 1.3

To: Christian Røsnes <christian@xxxxxxxxx>
Subject: RE: Linux 2.4.18 freeze running dbench 1.3
From: Austin Gonyou <austin@xxxxxxxxxxxxxxx>
Date: 05 Mar 2002 11:39:57 -0600
Cc: Keith Owens <kaos@xxxxxxx>, linux-xfs@xxxxxxxxxxx
In-reply-to: <LKEBKIBHKNEKEKPHFNCCKEHGCOAA.christian@xxxxxxxxx>
References: <LKEBKIBHKNEKEKPHFNCCKEHGCOAA.christian@xxxxxxxxx>
Sender: owner-linux-xfs@xxxxxxxxxxx
With that kernel used...can you dbench your ext2 filesystem and see any
difference?(i.e. does it crash too, or act funky?)

On Tue, 2002-03-05 at 01:51, Christian Røsnes wrote:
> I was unclear in my previous post.
> I meant to say that I did a full new cvs to checkout to an ext2
> partition
> on my system, to get a pristine copy.
> (My previous checkout was to a xfs partition.)
> I then compiled the kernel and modules on the ext2 partition,
> installed them and rebooted.
> The dbench was run on a xfs partition, where it crashed.
> I've compiled xfs into the kernel, and DMAPI is turned off.
> # CONFIG_XFS_RT is not set
> # CONFIG_XFS_DMAPI is not set
> Christian
> > -----Original Message-----
> > From: Austin Gonyou [mailto:austin@xxxxxxxxxxxxxxx] Sent: 5. mars 2002
> 01:16
> >
> > Did you run that test on EXT2 or did you just build your kernel on
> EXT2,
> > or did you run dbench FROM EXT2?
> >
> > Also, are you running XFS as a kernel module or built-in? Is dmapi
> > turned on?
Austin Gonyou
Systems Architect, CCNA
Coremetrics, Inc.
Phone: 512-698-7250
email: austin@xxxxxxxxxxxxxxx

"It is the part of a good shepherd to shear his flock, not to skin it."
Latin Proverb

<Prev in Thread] Current Thread [Next in Thread>