On 23 Mar 2001 20:14:16 -0500, K Mitchell Russell wrote:
> Interestingly, i reinstalled pr0.9, booted up fine. Then upgraded
> mkinitrd to 3.0.6, e2fsprogs to 1.19, and installed the
> kernel-smp-2.4.2-SGI_XFS_0.10.i686.rpm from the pr0.10test2. Then
> created a new initrd from the 2.4.2-SGI_XFS_0.10smp modules, and this
> boots fine! Perhaps there is a problem with the Wolverine installer
> creating the initrd...
Hm.... well, I did a full scsi install here on an adaptec controller
(aic7xxx driver) and it's a good news / bad news sort of thing - the
good news is that it all went fine, and booted right up. The bad news
is I didn't reproduce your error. :)
I'll take a look at what anaconda is doing... perhaps there is a problem
there.
Also, I'm not surprised that the boot floppy creation failed - kernel +
xfs + scsi driver is getting pretty big... I guess we should disable
that or at least offer a warning if we can't make it fit.
-Eric
|