Howdy All,
I finished my lmsensors pmda. It works quite well (ok, that's my opinion, but
it defiantly works better than the other pmda's I've written).
The reason it is only version 0.5 instead of 1.0 is because of two reasons.
1) I don't have it set up to do 'instances' (more than one of the same
thing). So if you have two of the same sensor, such as two lm75's, only one
of them is displayed. I did that because I've never done instances before,
needed to get this done, and so that was the one corned I cut. I do believe I
have the code written in such a way as to do instances quite easily.
2) I don't have all of the sensors that lmsensors can monitor, only the ones
that I have on my machines. This is once again, partly a time reason, partly
not. It's awfully hard to check your code, when you don't have anything to
check it against. I also couldn't figure out how they get the values that
they do for the eeprom, but once I do, I could easily put it into the code.
Current Sensors supported
lm75
lm79
w83781d
NOTE: You do have to have lm-sensors working to get this information. This
isn't something that installs lm-sensors for you. I just wanted to make that
clear.
Thanks
Troy
--
__________________________________________________
Troy Dawson dawson@xxxxxxxx (630)840-6468
Fermilab ComputingDivision/OSS SCS Group
__________________________________________________
lmsensors.0.5.tgz
Description: Binary data
|