Re: [PATCH 3/4] [NEIGH] neighbour table configuration and statistics via rtnetlink

[jamal <hadi@xxxxxxxxxx>]

On Tue, 2005-31-05 at 18:13 +0200, Thomas Graf wrote:

[..]
> So what I propose is to have the neighbour table parameters,
> e.g. everything in arp_tbl be distributed over RTM_NEIGHTBL
> and put the device specific parameters into devconfig,
> e.g. in_dev->arp_parms.
> 

Right, this is what i am saying a well.
The only caveat i was pointing out is that the devconfig piece is more
than just the neighbor stuff - and of course it hasnt been written,
yet;->
The major challenge will be events - some change via /proc, sysfs etc
should generate event.
I suggest something along usage of notifier_block with something like
NETDEV_CONFIG to transport these things around. Damn, if only i can find
my patch ....
I had already started doing events based on changes from /proc or sysctl
etc.

> Absolutely, more specific:
> 
> netdevice -> inet_device -> parameter set -> neighbour table
> or:
> neighbour table -> list of parameter sets -> netdevice
> 
> both ways are possible right now.

Sounds good to me.

cheers,
jamal