Lennert Buytenhek wrote:
On Wed, Mar 23, 2005 at 06:03:30PM -0800, Ben Greear wrote:
I have two 4-port e1000 NICs in the system, on a riser card.
How is the riser card wired? F.e. does it have a single edge
connector, and provides two PCI slots, or does it have a tiny
additional edge connector that routes REQ#/GNT#/INTx from a
nearby PCI slot, etc.?
I was able to reproduce the problem even when the 4-port e1000 NIC
is plugged directly into the motherboard, so it's not the
I also tried with a 4-port VIA-Rhine NIC (router-board 44). It also
fails it's third interface, with the same problem. So, it is not
the e1000 NIC nor the e1000 driver that is the problem.
I do notice that it is the same interrupt (26) that is always assigned
to the broken port. I have the lspci and dmesg output for the via-rhine
boot if anyone wants it...
Ben Greear <greearb@xxxxxxxxxxxxxxx>
Candela Technologies Inc http://www.candelatech.com