"Eble, Dan" <DanE@xxxxxxxxxx> writes:
> Krzysztof, I thought you had dropped off the face of the earth. Good to
> hear from you again. Did you ever see my changes to make the HDLC generic
> layer use the PPP generic layer instead of syncppp.c?
Not sure. Do you have a copy?
> I thought tcpdump/libpcap only looked at the device type, so that if we sent
> non-eth packets up an eth interface, tcpdump would try to interpret them as
> eth packets.
Sure. But we won't - with device type = Cisco HDLC tcpdump will be happy.
I.e. will happily print SLARPs, regular IP frames, and Ethernet frames.
Looks like it doesn't support it yet:
switch (proto) {
case ETHERTYPE_IP:
case ETHERTYPE_IPV6:
case CHDLC_TYPE_SLARP:
case CHDLC_TYPE_CDP:
case ETHERTYPE_MPLS:
case ETHERTYPE_MPLS_MULTI:
case ETHERTYPE_ISO:
but I can't see a problem with adding it, given the kernel code is
confirmed working so I can test it.
Note it's irrelevant to single hdlcX vs hdlcX + hdlcXeth0 issue, it
has to be done anyway.
> My primary reason for wanting a second device is to be sure
> not to discard information that is helpful/necessary for troubleshooting;
> so, if receiving packets with diverse header types is not going to mess
> things up, I would definitely prefer using only one device, because it is
> simpler to configure.
Receive side is definitely not a problem. Transmit side is and I think
we need two devices, at least for now.
> The case of using a Cisco HDLC link for bridged
> ethernet *and* IP *and* other things at the same time does not seem very
> useful.
But it's more elegant solution I think (the same would apply to FR PVCs).
It could be useful - with bridged Ethernet for MS Windows connectivity
and with routed IP traffic.
>> The only problem I can see (a serious one, though) is the protocol
>> "routing" in Linux. If we "ip addr add" IP address to hdlcX, does
>> it mean we want native IP or IP/Ethernet? It would be nice to be able
>> to:
>> ifconfig hdlc0 10.0.0.1/24 hw cisco-hdlc
>> ifconfig hdlc0 10.0.1.1/24 hw ether
>
> We could just use "sethdlc hdlc0 cisco-eth" and not worry about
> distinguishing in ifconfig, right?
Sure, but that wouldn't be "at a time".
I'd go with "2 devices" path for now. Long-term I'm going to investigate
"1 device" possibility. This depends on my future job = time I can
find for it, as my current contract ends by Sep, 1 and I'll be seeking
a new one (hope I'll have more time for Linux works than now).
--
Krzysztof Halasa, B*FH
|