Hi,
> Dear Becker,
Sorry for the typo... Please read it as "Hi List"....
But contents are same as I wanted to ask....
>
> I was trying to implement the physical identification
> for the 8139 series cards.
> For this I need to light the led of the card,
> when I need for the purpose of physically identifying it.
>
> After going through the manual, archives
> and writing some code, I have found that
> the lights of the led cannot be lighted by
> writing values to the "Config1" register's led bits.
> Neither does manipulating the values in the
> "CS" registers results in any led being lit.
>
> What is the way to light the led manually.
> I understand that according to the configurations
> set the led will light in case of the link, tx, rx etc.
> But I want to light the led explicitly.
> Is there a way to do it ?
>
> Regards,
> KK.
--
HomePage: http://puggy.symonds.net/~krishnakumar
|