| To: | andrew@xxxxxxxxxxx, netdev@xxxxxxxxxxx |
|---|---|
| Subject: | Re: Linux-2.6.3 : [eth0: Too much work at interrupt, status=0x00000001.] |
| From: | YOSHIFUJI Hideaki / 吉藤英明 <yoshfuji@xxxxxxxxxxxxxx> |
| Date: | Sat, 21 Feb 2004 03:20:06 +0900 (JST) |
| Cc: | linux-kernel@xxxxxxxxxxxxxxx |
| In-reply-to: | <200402201803.12146.andrew@xxxxxxxxxxx> |
| Organization: | USAGI Project |
| References: | <200402201803.12146.andrew@xxxxxxxxxxx> |
| Sender: | netdev-bounce@xxxxxxxxxxx |
In article <200402201803.12146.andrew@xxxxxxxxxxx> (at Fri, 20 Feb 2004 18:03:11 +0000), Andrew Walrond <andrew@xxxxxxxxxxx> says: > I'm getting loads of these messages in dmesg. > > This is a vanilla 2.6.3 kernel with ACPI disabled with acpi=off boot > parameter. No preempt, APIC and IOAPIC enabled > > Its a single 2Ghz celeron with Via chipset and Rhine II ethernet. It is under > no load at all. ssh only. > > dmesg is short and follows; Any knowledge apprieciated! : > eth0: Too much work at interrupt, status=0x00000001. I've got this several times, randomly, and I had to go to the console to reboot the machine. Well, sorry, I haven't tracked it down yet... Others? -- Hideaki YOSHIFUJI @ USAGI Project <yoshfuji@xxxxxxxxxxxxxx> GPG FP: 9022 65EB 1ECF 3AD1 0BDF 80D8 4807 F894 E062 0EEA |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [PATCH 2.6.3][NET/HAMRADIO] 6pack.c: timer code cleanups, Vinay K Nallamothu |
|---|---|
| Next by Date: | Re: Initialising net/ipv4/ before net/ipv6/ breaks IPv6 autoconf with nfsroot...., David Woodhouse |
| Previous by Thread: | Linux-2.6.3 : [eth0: Too much work at interrupt, status=0x00000001.], Andrew Walrond |
| Next by Thread: | Re: Linux-2.6.3 : [eth0: Too much work at interrupt, status=0x00000001.], Andrew Walrond |
| Indexes: | [Date] [Thread] [Top] [All Lists] |