Hi,
When i am trying to download the manual
of 8139C from realtek site, I am getting
8139C(L) manual. And as per that the
device id should be 8129 for 8139C(L).
So there is a possibility that if you
enable the CONFIG_8139TOO_8129 you might
get the card working.
Leo,
Have you enabled
"Support for older RTL-8129/8130 boards"
option in the make menuconfig(that will enable the
CONFIG_8139TOO_8129 )? If not then can you enable
it and try out ?
Regards,
KK.
On Tue, 2003-12-16 at 04:51, Jeff Garzik wrote:
> Leo Cambilargiu wrote:
> > Hello readers:
> >
> > I purchased a couple of encore ENL832-tx NIC's that Linux doesn't
> > recognize.
> >
> > they are based on RTL8139C (06117S1)
> >
> > The module 8139too (2.4.23) doesn't load. It behaves as though no
> > recognized hardware exists.
> >
> > Any comments?
>
>
> Probably you need to add PCI ids to 8139too.c...
>
>
>
|