On Thu, 16 Dec 1999, Guru raj wrote:
|>I have RH6.1.
|>
|>I downloaded linux-2.2.10 from www.kernel.org.
|>and the SGI kernel patch from oss.sgi.com/projects/sgilinux1.1.
|>
|>After applying the patch I compiled the kernel and created a new kernel image.
|>
|>When I tried to boot into this new kernel,after loading and uncompressing the
kernel, it gives the following message
|>
|>'unable to handle kernel paging request at ox______'
|>
|>It dumps the values of registers and enters in to kernel debugging mode and
stops at debugging
|>prompt.
If you're in KDB, what was 'bt' say? Do you have a screen dump of
the Oops information?
If you crashed on the way up, it may be long before the crash dumping
is configured properly in the kernel.
|>What might be the problem.
|>
|>LYCOShop is now open. On your mark, get set, SHOP!!!
|>http://shop.lycos.com/
I'm forwarding this to one of SGI's internal lists to see if we've
heard of anything like this. If you could let us know what hardware
configuration you're running with, including all PCI/ISA cards,
number of CPUs, memory configuration/layout/vendor, processor type
and speed, etc., perhaps we can make further progress.
Also, did your 2.2.10 kernel build and run properly without SGILE 1.1?
Thanks, let us know what we can do.
--Matt
|