info-inventor-dev
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: Open Inventor with Gtk+

from [Lars J. Aas] [Permanent Link][Original]
To: Spack Wad <spack_wad@xxxxxxxxxxx>
Subject: Re: Open Inventor with Gtk+
From: "Lars J. Aas" <larsa@xxxxxx>
Date: Sun, 4 Mar 2001 17:33:42 +0100
Cc: angbodhi@xxxxxxxxxxxxxx, info-inventor-dev@xxxxxxxxxxx
In-reply-to: <F1791s7nlT2NqFJ3sl300004445@xxxxxxxxxxx>; from spack_wad@xxxxxxxxxxx on Sat, Mar 03, 2001 at 02:44:21PM -0700
References: <F1791s7nlT2NqFJ3sl300004445@xxxxxxxxxxx>
Sender: owner-info-inventor-dev@xxxxxxxxxxx
User-agent: Mutt/1.2.5i 
On Sat, Mar 03, 2001 at 02:44:21PM -0700, Spack Wad wrote:
: I'll re-pose my original question then - since I'm a way better
: Inventor programmer than an Xt/GUI programmer - I was hoping to
: avoid more "manual" GUI generation...
: 
: Are there any Linux gtk+ GUI builders that I'll be able to get
: working with either of these OI component sets?

No.  Maybe later, but not now.

  Lars J
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: Open Inventor with Gtk+, Ang Bodhi
Next by Date:  Re: Updating states!, Jonathan Lim
Previous by Thread:  Re: Open Inventor with Gtk+, Spack Wad
Next by Thread:  Re: Problem installing OpenInventor on O2, Jan Prikryl
Indexes:  [Date] [Thread] [Top] [All Lists]