Mandrake 2.4.17-18mdk based on 2.4.18-rc1
On first (?) bootup after install the following interesting message
(error -17):
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0x1840-0x1847, BIOS settings: hda:pio, hdb:pio
ide1: BM-DMA at 0x1848-0x184f, BIOS settings: hdc:DMA, hdd:pio
hda: LS-120 CSMO 05 UHD Floppy, ATAPI FLOPPY drive
hdc: IBM-DTTA-371440, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hdc: 28229040 sectors (14453 MB) w/462KiB Cache, CHS=28005/16/63,
UDMA(33)
hda: No disk in drive
hda: 123264kB, 963/8/32 CHS, 533 kBps, 512 sector size, 720 rpm
devfs_register(disc): could not append to parent, err: -17
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Partition check:
/dev/ide/host0/bus1/target0/lun0: [PTBL] [1757/255/63] p3 < p5 p6 p7 p8
>
/lib/dev-state does not contain any manual entries, so it looks like
some internal kernel problem. Besides as I understood it was the first
boot after installation.
Full logs are available. Robert, I hope you give permissions to ask you
in case of any additional information needed?
> > > See my stuff.tar.bz2 attachment on previous post - that contains:
> > >
> >
> > Oh yes, sorry.
> >
> > Was it the very first boot after install? What is in /lib/dev-state?
(ls
> > -lR /lib/dev-state)
> >
> > -andrej
> >
>
> Per your request:
>
>
|